Home   |   About Us   |   Career   |   Contact Us
 
Products
 
Services
 
Technical Support
 
 
Products / Bearings House
 SNG Series
 
SNG housings are made by machine castings to grade ASTM-A48 class NO-30A or FG-210 grade; all the surface and edges are free from high/low spots appearing in straight plane/line; no casting burrs and blow holes; centre lines marking for easy and speedy alignment; in built dimples for easy location of oil/grease nipples, installation of vibration/temperature sensors or monitoring devices, easy selection for drainage outlet, locating pins for permanent positioning/alignment; flat machined base for better rigidity; bottom center rib carries higher load; screw driver gap at center height for easy split of housing, and special exterior design for greater mechanical strength. All SNG series housings have same serial code marked on the upper & lower parts of the housing to prevent mixing of caps and also to provide absolute perfect fit to the bearing.
 
  Following series and sizes are available under SNG :
 
  AXL SNG 500 Series   1200EK, 2200EK, 22200EK bearing with adapter sleeve
  Shaft Diameter   20 mm – 140 mm
   
  AXL SNG 600 Series   1300EK, 2300EK, 21300 EK, 22300EK bearing with adapter sleeve
  Shaft Diameter   20 mm – 90 mm
   
  AXL SNG 200 Series   1200E, 2200E, 21300E, 22300E bearing for straight bore
  Shaft Diameter   25 mm – 160 mm
   
  AXL SNG 300 Series   1300E, 2300E, 21300E, 22300E bearing for straight bore
  Shaft Diameter   25 mm – 100 mm
 
 
     
  Send Us Enquiry  
   
     
  Products  
     
 
 
 
 
  Home | About Us | Products | Downloads | Trade Enquiry | Contact Us | Site Map
  Copyright © 2011 Kay Kay Trading Co. All rights reserved. Created & Developed by Dotcom Service India Pvt. Ltd.